|
|
PRODUCT INFORMATION SHEET
 PRODUCT DESCRIPTION
All-Clean™ is a one-step, non-streaking, deodorizing cleaner. Not for use on food contact surfaces.
BENEFITS
- Deodorizes and cleans most porous and nonporous surfaces
- This product is a one-step ready to use deodorizing cleaner
- Will not leave grit, streaks or soap scum.
- This product is recommended for use as a deodorizer and cleaner on porous and hard, non-porous surfaces.
- This product neutralizes musty odors and tough odors from smoke, pet accidents, and spills on contact.
- This product cleans, shines and deodorizes all hard non-porous surfaces. It eliminates the odors caused by moisture, leaving bathrooms and kitchens clean and fresh smelling.
- Non-flammable
- Contains no phosphates, acids or alkalis
- Fast and easy to use, dries quickly after application
DIRECTIONS FOR GENERAL USE
Kitchen/Bathroom/Household Cleaning & Deodorizing: To clean and deodorize hard, nonporous surfaces such as floors, walls, counters, sinks, tubs, toilets, glazed tile, exterior surfaces of
appliances, refrigerators or freezers, microwave exteriors, stovetops and hoods, tables, garbage pails, faucets, etc. Apply as is with cloth, sponge, mop or mechanical spray. If a mechanical spray is
used, spray must be coarse. Hold container 6 inches to 8 inches from surface and spray until thoroughly wet. Best results occur when product is permitted to sit for up to 10 minutes. For heavily
soiled areas, a pre-cleaning step is required.
General Application:
This is a proven one-step cleaner and deodorizer. Apply this product undiluted to porous surfaces like: walls, floors, concrete and wood or nonporous surfaces such as tables, chairs, countertops,
sinks, glazed tile, glazed porcelain and bed frames with a cloth, mop or mechanical spray device so as to thoroughly wet surfaces. For porous surfaces like wood and concrete, wet surface thoroughly
and scrub with a brush. Let set for 10 minutes, rinse and repeat if necessary. If mechanical spray device is used, spray should be coarse. Spray 6-8 inches from surface. Rub with brush, sponge or
cloth. Do not breathe spray (mist).
NOTE: If spraying in a room where human or pet foods may be contaminated by spray, remove the food or cover to protect from over-spray. Wipe excess and allow to air dry.
General Deodorization:
To deodorize, apply this product undiluted. Excess material should be wiped up & allowed to air dry. For Deodorizing Garbage Cans, Garbage Trucks, Industrial Waste Receptacles and Garbage
Handling Equipment: It is especially important to preclean for the product to perform properly. Apply a wetting solution of this product and permit it to penetrate for 10 minutes before rinsing. For
Odors Caused by Dogs, Cats and Other Domestic Animals: Use on rugs, floors, walls, tile, cages, crates, mats, litter boxes, floor coverings, or any surface soiled by a pet. Test a small inconspicuous
area first. Blot problem area. Then follow directions for “General Deodorization”. Odor Control Directions: This product will effectively inhibit odors caused by high humidity and
insufficient airflow. Thoroughly wet all treated surfaces completely and wipe. Let air dry. Repeat application weekly or when odors and staining reappear. *For a general description of the typical
chemical and physical properties refer to the Material Safety and Data Sheet.
COMPATIBILITY
All-Clean™’s water-based formulation offers uniform dispensability and is compatible with a wide variety of materials. WARNING: DO NOT INHALE SPRAY!
STORAGE AND HANDLING
Read the label and Material Safety and Data Sheet for complete handling information before using this product. Store in a cool, dry place.
PACKAGING
All-Clean™ is packaged in gallons, pails, drums, and disposable totes.
|
